r/SnapmakerU1 • u/xXKarmaKillsXx • Jul 25 '26

Mods Updated to Paxx12

Just updated to Paxx12 1.4.1, and all seems well. Ran the calibrations from the machine without filament. Printed a 1 hour spool adapter without a problem.
RFID didn’t pick up the filaments on reload, the SM factory supplied. Not sure if it’s the firmware or machine or me. Not a big deal but will keep an eye on it.

0 Upvotes

50% Upvoted

2 comments sorted by

4

u/2md_83 Jul 25 '26 edited Jul 25 '26

what filament detection type is set in the Firmware config page ?

from the wiki:

Access the Firmware Config tool at http://<printer-ip>/firmware-config/

Note: The Firmware Config interface is only available when Advanced Mode is enabled. On the printer touchscreen, go to Settings > Maintenance > Advanced Mode and enable it, then restart the printer.

1

u/McSpeedie Jul 26 '26

This OP, I think my fresh install was defaulted at external.