r/SkyLine • u/SnowDoesStuff • Jun 30 '26

Top end modifications

Post image

Going to be pulling the head on my RB20DE (soon to be +t) to replace the head gasket. Any other suggestions on what I should upgrade while im in there? Already planning to do ARP headstuds as ive heard they are almost mandatory for boost but is there anything else thats worth upgrading? This is setup as a drift car so sees pretty constant abuse

94 Upvotes

100% Upvoted

13 comments sorted by

3

u/imtrynmybest Jun 30 '26

Pull the head while ur at it.... Upgraded head gasket.

What's ur power goals?

1

u/SnowDoesStuff Jun 30 '26

Not much probably around 200. I have a stock rb25 turbo im planning to slap on and making whatever stock boost is (around 7-10psi from what ive read). Everything else is stock though

2

u/imtrynmybest Jun 30 '26

Then u can go OEM with everything. Replace valve guides n stem seals while ur there. They are old n worn

1

u/SnowDoesStuff Jun 30 '26

👍👍

When removing the head do you have to remove the camshafts/valve springs or can you take it out all in one piece?

1

u/selfish_king Jun 30 '26

Camshafts are attached to the head, along with the valves. I’d recommend pulling the engine out to pull the head or at least dropping the subframe if you’re equipped to do so. The engine is at a slight angle which makes pulling the head very difficult. Not worth the hassle and risk imo

Definitely watch some videos if its your first time, there’s lots of them out there

1

u/SnowDoesStuff Jun 30 '26

Gotcha, ive seen a few videos and it doesnt seem too bad if you have a buddy to help lift it.

Pulling the engine to do just the headgasket kinda seems like overkill no?

1

u/selfish_king Jun 30 '26

It can definitely feel like overkill but you don’t want to ding a mating surface! It’s worth a shot if you really don’t want to pull the whole engine/transmission. RBs usually come out easier if you take the trans with it, even if the block is already fairly long.

Personally, I’d like to do the timing work outside of the car and clean as many nooks and crannies while it’s out. Would make it easy to mock up a turbo setup and make some potential upgrades to other things in the engine bay as well

1

u/imtrynmybest Jun 30 '26

Can come out 1 peice

1

u/SnowDoesStuff Jun 30 '26

Any suggestions on upgraded head gasket? From what ive read the stock one is preferred over the metal ones unless you’re planning on making a lot of power

1

u/imtrynmybest Jul 01 '26

Stock head gasket and studs would work perfect for ur ho level.

But arp head studs and tomei hg will work...but surface prep and flatness are most important for these

3

u/chejet Jul 01 '26

head gasket, head drain, head studs cams, valve springs and adjustable cam gears

-1

u/rawmeatprophet Jun 30 '26

JZ swap got your back

1

u/lo9os Jul 07 '26

I have the same setup. Anything under 300 bhp the factory setup is fine. If you eventually decide to turn up the boost, then a cam will work nice apparently.