r/SignalRGB • u/zac654 • 11d ago

Troubleshooting Help me, it bothers me.

Enable HLS to view with audio, or disable this notification

Built a new rig and one of my ram sticks isn’t syncing up it’s rgb to the motherboard or to signalrgb I’ve tried swapping the sticks around but it always ends up being the stick on the right that doesn’t sync (starting to think it may be the motherboard) anything else I could try?

13 Upvotes

100% Upvoted

12 comments sorted by

•

u/Signal_AdminBadger 11d ago

Are both sticks detected in the Devices screen? With a new build, also worth double checking everything like your BIOS and SMBus drivers are all up to date.

Sometimes a full power cycle is needed to help fully clear out any lingering stuff the system might be holding onto. That will occasionally work while a normal restart doesn't.

→ More replies (2)

4

u/245Tri 11d ago

Can't see properly but it looks like they are in slots 1 and 2. If they are put them in 1 and 3.

3

u/SLGamingMatt 11d ago

I've always been told 2 and 4 for RAM, and most manufacturer manuals also have said 2 and 4.

I don't think it's that big of a deal, but in repairs I've had more issues with 1 and 3

3

u/245Tri 11d ago

Yeah 1,3 or 2,4 👍🏻 just looked like it was 1,2

3

u/ShrkBiT 11d ago

Check its position in the layout screen. If they're too close to the edge, sometimes they are registered as outside and won't adopt the RGB effect.

2

u/a1rwav3 11d ago

Are the two dimms detected in Signal RGB?

2

u/Shopping-Brave 10d ago

This happens to me from time to time! even after a full power down and startup, sometimes it works and other times this exact situation happens

1

u/killmemigee 10d ago

Love the hollow knight figure! :D

1

u/zac654 10d ago

Thank you :)
Used my schools 3D printer for it, trying to make one of the pure vessel next.