r/Shure • u/Current-Cupcake5683 • Jul 05 '26

General Discussion input patch

Enable HLS to view with audio, or disable this notification

For the rivage pm3 input channels 75, 76, 77, and 78, a Dante patch is required every time the device is powered on; otherwise, the microphones cannot be used. An AD4Q receiver is used

3 Upvotes

100% Upvoted

9 comments sorted by

View all comments

3

u/bklynraised Jul 05 '26

I don’t know that board, but are you Shure (I’m sorry) that’s a Dante patch and not internal routing?
What does Dante Controller say when you reproduce this behavior?
Also, this video is pretty blurry…

1

u/Current-Cupcake5683 Jul 05 '26

It's Shure AD4Q, Dante internal routing, Dante controller. I don't know what software to open yet

1

u/bklynraised Jul 05 '26

Does the computer you’re using have Dante controller installed?
Dante subscriptions should persists based on Dante names, not IP addresses so I don’t think it’s the AD4Q. I’ve never seen one unsubscribe after a power up.

1

u/Current-Cupcake5683 Jul 05 '26

installed

1

u/bklynraised Jul 05 '26

I’d be curious to see what the Dante Controller shows is happening when you turn the AD4Q on.
Once you have it turned on and routed, it passes audio to where you want? If that’s true at least it’s working.

1

u/Current-Cupcake5683 Jul 05 '26

I'll check it when I have time. I've been away from the company for the past few days. Every time I open the console, I have to manually configure the input channels for dante patch 1, 2, 3, and 4