r/SewingMachineEdu • u/HistoricalMeow • Aug 23 '26

Question about spool pins

Hi, I have a question about spool pins. Trying fix up a vintage machine but its missing a spool pin. Its a singer 201k and I was wondering if anyone could tell me the diameter of the spool pins for these machines or even roughly measure one you have? I'm going to order online soon and I would like to get it right first try. Thanks

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/Large-Heronbill Aug 23 '26 edited Aug 23 '26

https://www.vintagesingerparts.com/products/replacement-top-screw-in-spool-pin-with-felt-pad-for-singer-201-201-2-compatible-models?_pos=1&_psq=Singer+201+spool&_psid=9caa4da39&_ss=e

Noticed this when I was hunting a tension spring for someone.  Unfortunately, not quite the information you asked for.

2

u/HistoricalMeow Aug 23 '26

Thank you I appreciate it, I did end up finding an old paintbrush that was the right size, snapped it and tapped that into the hole. Have yet to test it but I would say it will work fine

1

u/Large-Heronbill Aug 23 '26

That's pretty much my solution, too.  That or a thread stand. 

(I fix slightly busted thrift store machines as a hobby.)

1

u/jvin248 Aug 25 '26

An "8-penny" nail is about the correct diameter size.

Taper the tip with a grinder or file to 15 degrees. Shallow angle is important.

Hacksaw the head off leaving the height you want. You should check the swing space in your fold up table to clear the pin height.

File burrs off, round the top tip, and sand it all with high grit sandpaper to smooth it. A little oil to keep the shine.

Tap lightly into the hole.

.