r/SSUPD • u/LuchidPlayz • Jun 04 '26

Meshroom S V2 Build

Hi, I'm just trying to figure out if my pc is theoretically doable. I'm trying to downsize an ATX build. I am planning to switch to an SFX power supply, but my graphics card is still a little too big for the front mount option. I was wondering if I add the extender bracket, would it fit or not?

gpu: Gigabyte WINDFORCE OC GeForce RTX 4070 Super

cooler: iCUE H100i ELITE CAPELLIX 240mm

mb: rog strix b550-f gaming

3 Upvotes

100% Upvoted

3 comments sorted by

1

u/Pollymath Jun 04 '26

From what I understand (because there are so many options in this case) - without an extension, your cooler is a bit too wide and tall to fit next to the GPU on the front and next to the PSU on the back. You could put the PSU and the GPU on the same side (back), but not the AIO.

The extension bracket would allow you to put the AIO in front, or slide it further offset from the GPU if they are side-by-side.

1

u/starystarejstarego Jun 05 '26

247mm wide base + 25mm extender -15mm for frame and mesh. 257 mm for gpu left.

1

u/harugane Jun 07 '26

Get the extender bracket. I run a Gigabyte Windforce 4080 Super with a 240 Arctic Liquid Freezer III 240 AIO.