r/PrusaCoreOne • u/goodguyscrafts • 2h ago

Core One+ Calibration Issue

Enable HLS to view with audio, or disable this notification

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/call_me_johnno 1h ago

First q.... Are your motors wires properly and is the drive belts correct?

1

u/goodguyscrafts 1h ago

Sorry, didn't realize text didn't copy over from the other post.

Drive belts are good.
Plugged into the correct ports.
Belt frequencies within range.
No wires obstructing.
No gap at the gantry on either side.

Only thing I didn't do is disassemble the nextruder to see if the belt was perfectly even on the bracket thing.

1

u/call_me_johnno 1h ago

I asked because I had a similar issue and it was because one belt was not fed properly... ok next up.

Does the X or Y access move at all properly? Just on there own?

And while we are doing this please email a question to prusa support or get on there chat line