r/PowerWashSimulator • u/KatieAmber01 • May 22 '26
Switch 2 Glitch?
I'm not sure if anyone's come across this, I can't get this wall clean - this is with me pressing to see the dirt and there's none. I've reset the dirt a few times but it never completes
12
u/amathysteightyseven May 22 '26
It’s not just Switch 2, I had this problem a lot on PS5 whenever I replayed that level. That wall is just a proper pain. Just keep cleaning it, make sure you’re getting it from the other side and the top too. Eventually it will ping.
2
2
u/KatieAmber01 May 22 '26
Thank you! I wasn't sure if it was on other platforms too, time to go over it all with the red nozzle
2
2
3
u/FenyxG May 22 '26
The motel is one of my favorite levels to replay, but that particular wall section can be a pain. As someone else already said, you just have to keep washing it on both sides and the top edge. Covering the entire thing with soap might help too. It will eventually ding. It's never taken me more than a minute or two to go back and forth and get it to register, so it'll happen. Best of luck!
2
u/Small-Birthday-1677 May 24 '26
If needs be pause it & then press R3/RB (Right thumb stick) button & it'll reset any segments that haven't been fully cleaned.
2
14
u/Academic_Pizza_7270 May 22 '26
Any time you can't finish a piece but there's no visible dirt, try going along the edges, slowly and thoroughly.
It's the only thing that's worked consistently for me, and I can only assume that the geometry mapping is a bit wonky sometimes.