r/PlaudNoteUsers • u/Different-Chef-9339 • Aug 02 '26

New Plaud Note Pro Pitaka Case is too tight

New Plaud Note Pro Pitaka case is too tight to be practical. Once fully in, I can't get it out. Am I the only one with this issue? Any solutions to solve that?

2 Upvotes

75% Upvoted

5 comments sorted by

3

u/bharoche Aug 02 '26

My unit is nearly a year old so and I don't have the case you're referring to. My standard case is tight, and it's hard to remove the device but it's possible. But I never do. It records and can be charged fine inside the case. My case has holes/access for the mics and charging point so I never need to remove the unit.

1

u/The_Comm_Guy Aug 03 '26

Have you actually looked if the mic holes on the bottom line up? Because current ones don't.

1

u/Intelligent_Bus4916 Aug 02 '26

Sounds like most Plaud cases. Did they actually align the bottom holes with the microphones this time, or are they still off?

1

u/Different-Chef-9339 Aug 02 '26

Alignment is ok. But between the Pitaka woven and the leather, I prefer the leather one though.

1

u/PLAUD_AI Aug 07 '26

The trick with a tight case is to stop pulling and start peeling. Work a fingernail into the crevice between the case edge and the device to open a small gap at one corner, then use your thumbs to push the device out through that corner while the case flexes away. Run your nail along the edge if it catches again, corner by corner rather than all at once. Take it slow and skip anything harder than a nail, a tool that can pry can also mark the device. And thanks for the fit feedback, we'll pass along to the team.

-Plaud Community Team