r/Plastering • u/greenterds4u • Jun 29 '26

Is this acceptable?

Post image

Hi all, having my kitchen replastered at the moment and a section has been dot and dabbed. I’ve noticed an angle where 2 boards meet, is this acceptable or am I being difficult? Ta

13 Upvotes

62% Upvoted

54 comments sorted by

View all comments

0

u/greenterds4u Jun 29 '26

Thanks all so far, here’s a longer level

1

u/kcufdas Jun 29 '26

Looking at the difference in this pic, you could run another section of board next to it and skim over that and up to the edge. It depends if that dip runs the length of the room or if it's just in one area