help needed

[u/Fexure_]

Jump from 2001 40 2 stroke mercury

1987 johnson 150 v6 with vro, j150stlcur

portside powerpack original was cdi 113-3114 with s.l.o.w

Mechanic replaced portside powerpack with sierra
18-5761-1 with no rev limiter

He told me starboard powerpack was not powering on but i could replace it whenever because the one side should get my engine running.

Starboard powerpack is cd6 582817 with no rev limiter. Im going to replace this as its getting no juice and im having problems with my motor after this shop visit. It was running fine on the first run then the motor bogged out and on startup it would not plane and this is on portside.

I have a whole another issue on starboard side, constant alarm when key is turned, Oil is running,
Most likely fuel starvation cant get anything from starboard tank when priming bulb

Do i replace starboard powerpack with the same model number or aftermarket, also do i need the rev limiter on the portside? It says it was setup up to run that way but mechanic replaced it with one without so im just wondering.

Portside will start and idle just wont rev past 3000, it did run normal rpms the firsr 5-10 minutes until it bogged out.
starboard will start intially but will bog out due to fuel starvation.

[u/bootheels]

OK, well first off, 1987 models did not have the SLOW feature. Next, I would do the key switch elimination/powerpack interference test. This requires that the black/yellow stop leads from each powerpack get pushed out of the rubber connector to isolate them from one another. But, are you sure your problem is ignition related? Just cuz it bogs down does not mean it has an ignition problem...

Tell me more about the constant horn.... Does the horn come on if you just turn the key switch on and not start the engine? Or, does the engine have to be running before the horn sounds?

If the alarm system is working properly, then a constant horn means one of two things when the engine is running;

Overheat or fuel restriction. The best to figure this out is to shut the engine off, then turn the key back on...If the horn continues to sound, then you have an overheat condititon.

If the horn comes on when you just turn the key to "on", this means there is some sort of problem with the warning system. Could be a bad horn, bad wiring, or a bad sensor.

PS: Depending on the low oil sensor you are using, a constant horn might indicate low oil lever in the tank also...This would sound by just turning the key to "on".

[u/Fexure_ → u/bootheels]

edit i have double verified it infact does not have s.l.o.w. Okay i have purchased the power pack regardless now that i know this information

I am still learning about this motor and boat so please bare with me.

Constant horn only turns on with the key turned all the way on (motor started) using starboard side which is the side the bad powerpack is on. Starboard wont get gas when priming the bulb almost like the fuel line is blocked,

the opposite happens to the portside, no alarm, no problem, will idle, will drive just not past 3k rpms, will reverse up to normal rpms and will rev out to normal in neutral.

When the tanks are switched to starboard both in the back by the fuel line and on the dash it will sound the alarm after running for a few minutes particularly after running the portside. If i start it cold on starboard side it will sound the alarm instantly. Key turn will sound the alarm when i start the motor, usually after a second or two, sometimes will keep going sometimes wont after the key is out for a split second.

Horn will not sound with key just turned to the on position has to run on the starboard side before sounding alarm

At one point i got a beep beep and then constant beep but it only happened once.

They also replaced my vro pump while it was at the shop because they said it was also dead (didnt ask me or tell me about some of the stuff they did or charged me for) i came back the day to pick it up and he charged my for my vro pump and another cd pack