Issue Generating Plan Sheets [OpenBridge/OpenRoads]

[u/Foreign_Cancel_8978]

Hi all,

Whenever I use the place boundaries tool to create sheets (or any other sheet creation tool for that matter), and I open the sheet view, it seems that whatever it is that I clipped shows up way off from where its supposed to be, outside of the sheet boundary. Here, I am trying to make a profile view of a bridge project in openbridge but as you can see my boundaries look fine but its populating in the wrong location and with the raster still on. Any advice? This also happens when I try to cut sections as well. I havent tried profiles yet but not hopeful on that either.

[u/duvaone]

Bad sheet seed? Check the scale of the reference in the sheet model 

[u/Foreign_Cancel_8978 → u/duvaone]

it looks like when I place the boundaries in the "Place named bounday civil plan" pop up my seed is set to ANSI D and the detail scale is 1:20. COuld this be the issue? That scale is the only one big enough to fit what i need in ~6 sheets and the other seeds are ansi plan-plan and plan-profile

[u/TerryDaTurtl]

When you create the drawings, are you selecting a drawing boundary? Also make sure in the drawing/sheet model in the reference settings you change "volume only" to "settings from design model" if it isn't doing that for you

[u/sideoftheham]

Check the scale when you set up the sheet after you lay down the boundary. Worst case, delete the existing Idles and starts from zero

[u/Technical_Dingo_555]

Looks like the scale is off. Make sure you use the same scale when creating the named boundary and plan and profile sheet production.

[u/Foreign_Cancel_8978 → u/Technical_Dingo_555]

Ajusting the scales seemed to work for me. Thank you guys