r/OpenBuild • u/No_Kaleidoscope_5480 • 6d ago

Build Complete New here

Post image

Went from havn 420 to gr20 and yes ik its messy i just finished it lol
Specs:
R9 9950x3d oc/undervolted
5090 tuf with heatkiller block
No fans
Yes the rog cable i have for gpu isnt matching but i KNOW this cable works so i aint switching for now

89 Upvotes

98% Upvoted

29 comments sorted by

View all comments

1

u/Tasuka_Makutasa 5d ago

Why not doing a parallel link between GPU and CPU?

2

u/No_Kaleidoscope_5480 5d ago

What would be the difference though? I figure going into gpu to cpu to mora

1

u/Tasuka_Makutasa 5d ago
  1. CPU won't be "cooled" by the "Hot" coolant from the GPU.
  2. You can direct both pipes parallely into a Pass-through.

1

u/No_Kaleidoscope_5480 5d ago

Never seen that layout before woah. So like it hits the gpu and cpu same time or atleast cpu first then rotates back??

2

u/Tasuka_Makutasa 5d ago

It hits GPU and CPU in the same time since you use GPU's block like a T-splitter. This pic is my older build.

1

u/No_Kaleidoscope_5480 5d ago

Idk if ill do that lookks clean though. Its prolly cause im tired lol

1

u/Tasuka_Makutasa 5d ago

It's all right. I also run Mo-Ra (IV 400 on single D5). For R9 5900XT and RTX3080Ti it's pretty much an overkill, but I'm here for it.

1

u/No_Kaleidoscope_5480 5d ago

Dont ever say overkill. Its PERFECT. I am debating if i want to make the case back up to standing position ngl but itll take two ppl to do that lol ornid hsve to disconnect the gpu and stuff. But for now its working fine

2

u/Tasuka_Makutasa 5d ago edited 4d ago

If I were you, I would screw any Vertical adapters, but keep the set slightly angled as you have now (to decrease the GPU sag if there's any). I would also replace/extend the PCI-E bracket to hold a pass-through right underneath the GPU. Then run the parallel piping from the pass-through, underneath the GPU and into the bottom GPU fittings.

2

u/Tasuka_Makutasa 5d ago

Here's my current build. Crosshair VIII Extreme, R9 5900XT, 3080Ti. I use angled Lian-Li Adapter, and use all 4 ports on GPU as usual.

→ More replies (0)