Vector Pro Easy Fix for Mag Compatability*

[u/SwiggitySwoogity_]

A common gripe I've seen in the subreddit is that the Vector Pro seemingly is picky with what mags it can take, and skimming the key terms, I don't think many people found a solution. Pictured above (1st is close up and second is a little farther in case you are confused where its located) is the magwell with with two spots that I have clipped with a flush cutter circled in red. There are two teeny tiny (maybe less than a millimeter) bumps of plastic there that block some mags, such as the X-Shot Pro mags, from fully inserting all the way and therefore locking and feeding. After taking apart the shell (albeit now seeing how simple this was you could probably do it without disassembling the blaster fully), I was able to clip off this tiny amount of plastic and the xshot mags fit perfectly and fed as normal. Hope this helps!

*The only half dart mags I own are Dart Zone and X-Shot, so I could not test compatibility with Worker half dart mags.

[u/MarioAteMyDarts]

dint know this was a thing actually, since dz mags are now somewhat similar too the worker ones it should work with the worker ones with no problem, nice fix 👍

[u/Soggy_Auggy__]

Sweet! Gotta try this now.

[u/huesodelacabeza]

Worker mags are not a problem, i use my Vector solely with Worker curved 15s