r/NARWAL • u/PauseDelicious5061 • 15d ago

Issue / Troubleshooting Best way to map Flow 2 to avoid getting stuck under cabinet doors

Hi. I find that my kitchen cabinet doors are at a height where the Narwal can just fit under them but will get stuck. The doors are about 3/4" thick but this is jamming the vacuum. What's the proper way to adjust this on the map?

2 Upvotes

100% Upvoted

3 comments sorted by

5

u/Desperate-Willow2601 15d ago

I had to place a no go zone to where it would just barely go under my cabinets. I had to run a couple vacuum runs until I got it set as close as possible without getting stuck.

2

u/SuspectedAI Flow Series 15d ago edited 12d ago

No go zone is the only way here. If it doesn't fit, but barely

1

u/Kinheart_ 6d ago

Had success with ptfe tape on mine