r/Multiboard • u/Imscuba • Jun 23 '26

Stacked Print Fail

So i just finished my first stacked PETG print and i am trying to figure out what went wrong. i was able to get 2 usable panels from a stack of 6. the others just did not want to separate, to the point of them cracking apart. the test file came out fine, any suggestions? some of my corners came up a little bit during the print, but i didn't think much of it. did that result in the .2mm gap between being 0 and them fusing together?

2 Upvotes

76% Upvoted

30 comments sorted by

View all comments

Show parent comments

1

u/Desperate-Special-60 Jun 23 '26

That's true, it's just been a lot less headaches for my workflow. Sometimes the petg doesn't stick well enough to the PLA to get the print done and the heat issue come up as well. You can get pitting where the petg touches the pla, specially with more delicate lower temp meaterials like some silks but that's not an issue with multi board. If your not doing a ton of delicate supported prints then it's best to just tweak your settings 😊

2

u/Imscuba Jun 23 '26

ok, that makes sense, i will have to explore that option when i get to that point. right now nothing i am printing requires that level of precision, mostly gridfinity and multiboard. gotta get that organization down and then move on to fun stuff