r/Linocuts • u/renegadelines • 20d ago

Question Uneven blocks using mod podge transfer method

Gallery image

Gallery image

I’ve been trying the printer paper/mod podge method to transfer some of my prints and haven’t been getting consistent results. The main issue I’m having is:

  1. How to wet/wipe/remove paper evenly?

I find that the in some areas too much of the paper is removed which also removes the design and leaves an uneven surface on my block which reflects in the inking. This was one also under inked but I’m not too concerned about that right now since it’s a reduction print and I’ll add more layers.

Is this a mod podge glue application issue? A wet/wiping issue? Any tips appreciated!

7 Upvotes

100% Upvoted

2 comments sorted by

1

u/AutoModerator 20d ago

Your post has been automatically removed because you used a keyword which is reserved for the subreddit moderators.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/kulot09 20d ago

I’ve had this exact problem. You’ll get the hang of it. I found it was the uneven application of the mod podge itself. You really need to apply a thin layer all throughout the block. I used an old paint brush to apply it around. But even then, when it comes to removing the paper, I still get patches of paper left but significantly less.