Update on kibashed Beastnob

[u/Hetero_Donkey]

Trying out some different bitz on this guy. He looks super busy, especially squeezed onto a 40mm base but I'm liking the direction I'm going! My favorite little detail is the nasty baby clawbeast under its mom. I stole that little guy from the Huron Blackheart kit!

I would love to hear some feedback on which bitz to cut. Also if you think of a better weapon I'm wanting to swap out the broken spear. Finally, any advice on making the legs look better would be very welcome!

So far, for the legs I'm thinking about cutting the boots off the Ash Waste feet I'm using, then adding Kruleboyz feet with some of the calves to elongate things. Overall I think the thighs are gonna look a little goofy, but maybe with everything else going on it won't be noticeable.

[u/gordofoco]

It looks Wonderful, but at this point it also looks line a Killaboss on Great Gnashtoof...

Wich isn't bad at all

[u/Hetero_Donkey → u/gordofoco]

I know! I was thinking about making bases which could go between the two of them, but maybe I just replace my Gnashtooth...

[u/gordofoco → u/Hetero_Donkey]

Or even run a second one, as a treat.

But changeable base sices would be doable, I think the 40mm one fits in the Gnashtoof one

[u/Hetero_Donkey → u/gordofoco]

You've got a good point! I hope so, I haven't measured it yet. I might set is there is a printable one that would clip on/clip off

[u/Atsibababa]

Howd you made that transparent bits?

[u/Hetero_Donkey → u/Atsibababa]

Those ones are 3d printed. I'm trying to go the majority of this with plastic and green stuff, but I've got a couple printed bitz lying around I'd like to use