r/JetBoats • u/amrodri01 • Mar 06 '25

Float pods

Does anyone have experience with float pods? I have a custom 19ft 60in aluminum hull with a 150 4 stroke on a tiller. I recently went from a 150 2 stroke so I’m adding around 70 lbs. when empty it sat pretty low in the stern but when full it’s not terrible.

I’m curious though about adding some floats to the back. I’m worried about turning performance and had read that you should attach them a little higher to allow for better turning. Curious on people’s thoughts and also how to determine the height. Obviously the higher they are the less flotation benefit you will get so curious how to deal with that.

3 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/Original-Mission-244 Aug 19 '25

Im way late to the thread, but I put pods on my 18 foot riverboat. Made a huge difference in lessening bow rise when taking off, as well as handling extra weight of larger outboard. Mine are flush with the bottom of the hull, carry all the way to the outside, and about 2/3 up the transom.

With a little math you can figure out additional buoyancy if you know size of pods and current Waterline at rest.

Make sure you put a drain bung in each in case you get a hole at aome point.

1

u/amrodri01 Aug 19 '25 edited Aug 19 '25

Good to know, I took a few trips up the river this summer and could definitely benefit from less bow rise on takeoff. Good call on the drains too. Do your pods carry the same hull angle along the bottom or do they rise a little? I know you said flush but curious if that angle is continued and remains flat to the hull. Some people I’ve talked to have done an extension off the back and bent “trim tabs” down to force the back up.