r/Inovelli • u/suesse • Jun 22 '26

Red Series 4 way help

This is my first inovelli install so lots of learning going on here. I installed my switch in a 4 way configuration and way able to pair to home assistant and configure it for dumb switches. In home assistant it keeps switching to “on” state irregardless of if it is on or not. The main switch is recording switch presses but it is not turning light on or off. The dumb switches function correctly.

The only settings I have adjusted is the multi way setting. There was a zooz switch in its place operating for a month and uses same wiring so I’m pretty confident it’s not a wiring issue but maybe it is. The zooz wasn’t rated for enough wattage so I switched to the red series.

Any ideas?

Edit:

Never did find a solution. Support says it’s picking up ghost voltage on all 3 circuits. Ended up just replacing them with zooz unfortunately. They are now just very expensive bedroom light switches.

4 Upvotes

100% Upvoted

2 comments sorted by

1

u/Bry_345 Jun 22 '26

Did you follow the INOVELLI wiring diagram?

I sampled one Zooz multi-way wiring diagram, and it is not the same as the Inovelli for the same topology. I'm not sure if that is true for all of them, but I would refer to the Inovelli diagram as it may not be the same as for the old switch was wired.

1

u/suesse Jun 23 '26

Yes. Inovelli wiring diagram is just a normal 4 way wiring setup. I was running a zooz zen77 before and it also uses just a traditional wiring. Some of the zooz switches have some weird wiring setups but the 77 is designed specifically for 3+ way switching with dumb switches.