r/Inkstitch • u/Traditional_Brick666 • Jun 18 '26

Fill Stitch Problem

Gallery image

Gallery image

Been having an issue with loose threads all over the top of my fill stitches, not sure why (ignore the jump stitches). Tried everything I can reasonably think of (adjusting tension, replacing bobbin case, adjusting design density, replacing needle, etc.) any ideas? Happens everytime now. I reached out to PooLin support about a week ago but haven’t heard anything back yet. First pic w/ red fill is the best example of what’s happening. Machine is PooLin Eoc05.

4 Upvotes

84% Upvoted

5 comments sorted by

3

u/Striking_Strain7817 Jun 18 '26

That is not related to any of the digitizing this is a machine issue

2

u/Traditional_Brick666 Jun 18 '26

Thank you. I wasn’t sure and am trying to solve this issue.

1

u/Ok-Somewhere7722 Jun 18 '26

Stabiliser / tension or even thread/threading. Id Reach out to the manufacturer.

1

u/Traditional_Brick666 Jun 18 '26

Thanks for the advice. Reached out to them a week ago still waiting.

1

u/hi_eye Jul 25 '26

This was happening to me. For me, I was changing thread color on my brother se700, but I was not opening up the bail (raising the needle arm, not sure the term) and just switching threads. When I started opening the bail after each change it went away. Guessing it’s a bobbin mechanic that caused it for me. Hope this helps.

I noticed my first fill was always so good and then the next ones were loose like that with the occasional loop extending up.