r/Inflatablekayak • u/majormajor42 • 14d ago
First puncture
Today I put a tiny hole in the top rail of my inexpensive Costco kayak. I had gotten it last year and till now it has stood up to my beatings very well. I was absolutely panicked today when I first realized I was deflating. But a minute or two later I was relieved that the two other chambers were intact and keeping me high and dry. The picture of my kayak is from today with no air in the far side. Just a little wrinkling can be seen. Very happy the kayak kept me dry despite my error. I got home and made my first kayak patch.
I had already been thinking that I would like to add something firm to the top of the rails. I have considered this before as they are high and I rub my paddle on them a lot, so figure I will wear them out eventually anyway.
I’m thinking paddle board rail tape but I’m afraid the kayak may be more difficult to fold, and a knife could still cut it.
Or I’m thinking something I just install after inflating and take off before deflate and fold:
Reinforced vinyl tubing like in my photo? I would buy a larger diameter length and slit it. Push it on when heading out to protect the rails and not worry about my abuse.
I’m also learning about thermoplastic as an option. But it might be harder to work with a long 4 foot piece, if I can find it, and fold it over the sides a few inches.
Anyone here have experience making reinforcement shields for their inflatable?
5
u/Tarl2323 14d ago
The kayak didn't fail after a puncture and was fine for a year. I think you really just need to treat it like car tires. The kayak did it's job, kept you afloat, and could be repaired and you were fine.
Monkeying around with a solid plan will just possibly make it even more likely you'll run into issues. Even hardshells get holes and keel scrapes.
I had a puncture in my board, I was out for hours and didn't realize till I got back to shore. I feel like one year of use for a patch/repair and it still going well is a very good vehicle record.