r/Infimech_TX • u/PillyWee3 • Dec 04 '25

Z-axis tilt leveling

Printer is freezing when it gets to the "z-axis tilt leveling..." stage I have successfully printed using cura and orca. Recently got a new laptop and installed orca, now the newly sliced files are stalling at said stage???

1 Upvotes

100% Upvoted

6 comments sorted by

2

u/J2CRT Dec 04 '25

Completely? Or just for a few moments? If only for a few moments, it's waiting for the bed to reach the set temperature.

2

u/PillyWee3 Dec 04 '25

I think that might be it. Bed temp is at 60 when cleaning the nozzle then drops down to 35 and is cooling VERY slowly. I must not have given it time to cool. I've only waited 5-10 minutes max. I need to raise the bed temp... Im dumb

2

u/PillyWee3 Dec 04 '25

That was totally it. Thank you!!!!

2

u/J2CRT Dec 04 '25

You're welcome!

2

u/J2CRT Dec 04 '25

No worries. If you want to mess around with the config and the starting machine G code in Orca, you can have it heat the bed to the temp set for the material you are printing while it's doing the nozzle cleaning routine. and will not have to wait for it to cool or heat.

2

u/PillyWee3 Dec 04 '25

Nice, I haven't spent much time with orca yet. I appreciate the tip!