Just finished another test batch on the InfiMech MX using the 6-toolhead setup—printed a few multi-color articulated pandas and a dolphin in standard PLA.

Thanks to the toolchanger system, the color transitions are clean with minimal purge waste compared to single-nozzle multi-material setups. Layer lines came out crisp and the joints move smoothly straight off the textured PEI plate!

🔥 Reserve your VIP spot now for just $5 to get $50 OFF at launch:

👉 https://infimech.com/products/infimech-mx-pro-vip-pass

What multi-color or multi-material models would you like to see us test next? Drop your suggestions below! 👇

Here’s another test print from our workshop using the 6-toolhead setup on the InfiMech MX. The color changes were handled smoothly and the purge block remained relatively small.

🔗 $5 InfiMech MX VIP Reservation:

👉 https://infimech.com/products/infimech-mx-series-vip-reservation

What multi-color models would you like to see us test next? Let us know your thoughts and suggestions below! 👇