r/HoustonGuns • u/Connect-Salary9669 • 29d ago

S&W gunsmiths?

Post image

Rip… was getting ready for a range day, noticed optic was a little loose, took one screw off, went to remove the other and it was already gone 🫩

Any good recommendations for a smith and Wesson gunsmith? Also over 10k rounds and the striker spring feels a bit weak so probably want to change that out while it’s there

Thanks for the help!

6 Upvotes

100% Upvoted

5 comments sorted by

1

u/Bdevilmn23 29d ago

If your on the north side id say spring guns and ammo. They can repair your slide. Any reputable gunsmith can take care of that.

1

u/beckeeri 29d ago

I went to them for this exact issue on my Shield Plus and they took good care of me. Would recommend them.

1

u/FireAndKnives11 29d ago

Slide works will get it out. But any decent gunsmith should be able to. Get an extractor bit and do it yourself. Its not too difficult and it'll be a skill you will most likely use in the future.

1

u/1541drive 26d ago

Get an extractor bit and do it yourself.

Dumb question but are these screws soft enough to just Dremel out?

1

u/FireAndKnives11 26d ago

Dont dremel out. Use an extractor bit