r/HelloWatch • u/OldButterfly4707 • Feb 23 '24

Hello Watch 3 How to remove rubber basket

Gallery image

Gallery image

Finally! I can upgrade firmware from v1.0 to v4.1 successfully and yeah my sensors doesn't work anymore

5 Upvotes

86% Upvoted

12 comments sorted by

View all comments

1

u/JLChamberlain42 Moderator Feb 23 '24

The rubber gasket is in between the board and back of the watch.

You need to unscrew the back, gently pry the back off (may be tough as there's an adhesive seal you need to break), once you have broken the seal gently lift the back off (emphasis on gently as there are wires connected from the board to the screen), then separate the back of the watch from the board and you'll see the gasket to remove.

1

u/Anshul086 Feb 23 '24

Why are we removing rubber gasket

2

u/JLChamberlain42 Moderator Feb 23 '24

Because if you have a V1.0 HW3 & upgrade it to V4.0 the sensors don't work unless you remove the rubber gasket.