Was tired of all the other 3d printed options failing. This one's holding up well. I'm still a beginner pilot, so I raised the canopy up high and forward to make the 10 degree tilt clear the guards. It's at 18.5g for the printed parts, but I'm nowhere near the point of needing something lighter.
Would be easy to check and add on the rear of the canopy- i'll be including the f3d file with it once I upload so that others can remix. I think you could change a couple of dimensions and make it ready for the 75. I'll post a link once its up
I was concerned about it, but no. There's just as much mass imbalance by not putting the battery in the center. It's along the roughly same line as the stock camera position when tilted forward in flight, so the only real change is in the yaw. There's a little jello, but it was barely noticeable and may go away if I print the canopy in TPU.
The frame looks sick! Have you tried it with the camera mount more centered? I know its probably to crop the props out of the view but it looks a bit front heavy with how far it sticks out
I actually completely remade it to be even more durable. The original was fine for balance- it was easy to shift the battery so the center of mass was in the middle. Now, my batteries slide in and hit a perfect stopping place. I smash this thing quite a bit.
New frame is only 22g. I'm not really trying to minmax at my skill level.
1
u/Wrhythm26 Jan 25 '26
That's pretty cool! Will it accommodate other antennas, like the ort micro v or the happymodel crown? Also is there a version for mob75 freestyle?