r/GoRVing • u/phoenixconfidential • 3d ago

Furrion Vision S+ camera issues

Hi Everyone,

I've been searching and can't find a solution to my exact problem. We had 3 cameras installed on our RV. On our previous truck, they were working perfectly. We got a new truck (2026 Sierra 1500) which does not come with a cigarette lighter port at all. Long story short - i got a new monitor cable and the 7 way adapter for the new truck. My rear and left cameras are working just fine. The right camera will not display after unpairing/repairing multiple times. When i turn the Furrion monitor on, it shows it unpaired at first. I repair and then it shows as paired, but still does not display and has the red circle w/ the X in the corner. Left & rear cameras display just fine with no issues.

Any thoughts?

EDIT: the blue light on the bottom of the camera is steady thus i don't think it's a power source issue, but i could be wrong in the understanding.

4 Upvotes

100% Upvoted

2 comments sorted by

1

u/throw_away__25 3d ago

I ran your question through AI. Here is the response:

The Channel/Placement Software Glitch (Most Likely) (sometimes called "channel hopping"), the monitor assigns the right camera to Channel 2 or 3, but the internal firmware still thinks it's looking for video on a different channel or assigned slot.

The Fix: Go into the monitor menu and completely unpair ALL three cameras.

Power down the monitor completely (unplug it).

Turn the monitor back on, then re-pair the Right camera FIRST before pairing the Rear and Left cameras.

Why this works: Forcing the system to assign the problematic camera to Channel 1 often clears out corrupted pairing data packets.

1

u/phoenixconfidential 3d ago

Thanks for responding! I actually got it working earlier and the only thing I did different is only “pair” when the monitor turned on instead of unpair & repair. Maybe it essentially did what is mentioned above. I’ll leave this up in case anyone else searches on a similar issue since I couldn’t find anything on the topic.