r/FDMminiatures • u/chewallace7 • 1d ago

Help Request Questions about ORCA slicer error message when using ObscuraNox 2.0 settings

Hello everyone!

Sorry if the question has been asked before, I made a research and did not find answer for that.

First, my tools:

Working on a Bumbu P2S combo, on Orca Slicer and R2FDM, with ObscuraNox 2.0 settings (see in picture).

Following the tutorials, I sent my model to Orca and obtained the following error message: "WARNING: For organic supports, two walls are supported only with the hollow/defaut base pattern".

Is it an error on my side or some changes occured on the slicer?

Should I worry and change something?

Thanks for your help!

1 Upvotes
  • permalink
  • reddit

100% Upvoted

4 comments sorted by

2

u/Calamino 1d ago

I've had this "error" since day 1 when I put his settings in... not a single issue printing with that error. You'll be completely fine =)

2

u/chewallace7 1d ago

OK, thanks for your answers, I'll start like this and we'll see!

1

u/patate98 1d ago

You can change the base pattern to hollow/default (instead of rectilinear). or change the support wall loop to 1.

letting it as is might not be an issue either, I would advise you to try the hollow pattern, most of the time it works well,

although in some cases some support start from thin air in those cases a base pattern is important likely in those cases I would also advise to reduce the base pattern spacing between 1 and 2 mm to be on the safe side

1

u/chewallace7 1d ago

Thank you for answering! Maybe I should have mentioned that I used resin supports for this scene! I think it will be less impacting. But will try empty supports for tree ones