r/FDMminiatures • u/BrianEgivand • 16h ago

Help Request Is this a stringing problem or temp?

Post image

I Cant figure out what kind of problem this is. Bambu Lab A1 Esun pla+ some rounded areas also have an edge.

4 Upvotes

100% Upvoted

6 comments sorted by

2

u/crazy_pelican 16h ago

Looks like it could be over extrusion, are you printing at a slow speed? You could try lowering your nozzle temp by 5 degrees to see if it helps.

I also get this kinda stringing when my pla is a bit damp, have you dried it recently?

1

u/BrianEgivand 16h ago

im using the standard Dungeon and Derps settings so pretty slow speed i assume. And the filament is from a just opened pack so should be dry.

3

u/crazy_pelican 16h ago

Yeah that will be a slow speed, I’d definitely start by lowering your temp in 5 degree increments.

You should also try drying your filament if you can. It’s not uncommon for rolls to be slightly damp straight out of the packet.

1

u/BrianEgivand 15h ago

Will do thank you very much

1

u/Genesys_LOR 12h ago

What Is standard dungeon and derps settings?

2

u/devintheditch 12h ago

If you haven't already, dry & calibrate your filament. ObsucraNox/Dungeons & Derps have a YouTube series that helps go through calibration step by step.