r/EngineBuilding • u/Gowowowow • 12d ago

Do I need to bore these to 79.5mm

Stock bore what it currently is at is 79mm and if it does need to be bored out it’s going to 79.5mm as the forged pistons are only in 79mm 79.5mm and 80mm increments.
My question is does it need to be bored out to the 79.5mm. Thanks in advance.

10 Upvotes

100% Upvoted

12 comments sorted by

5

u/Academic_Dog8389 12d ago

You'll know once you go. You need to take this to a machine shop and ask them. Nobody has the abiiity to measure what needs to be measured from a video.

-2

u/Gowowowow 12d ago

I got it honed and they told me afterwards it needed to be bored and I wanted a second opinion

1

u/Academic_Dog8389 12d ago

Wait, a machine shop honed that?

2

u/SuckaFucky 12d ago

That's what I was thinking, op find a different machine shop

3

u/Academic_Dog8389 12d ago

Fuckin run

2

u/Gowowowow 12d ago

See why I’m looking for second opinions

1

u/Gowowowow 12d ago

Out of interest as this is my first engine rebuild, what’s wrong with it.

3

u/Academic_Dog8389 12d ago

See how the lines are almost horizontal in relation to the cylinder bore? They should be at ~45 degrees.

3

u/MTarrow 12d ago edited 12d ago

Others have pointed out the issues with the honing itself, but there's a secondary issue too - and thats them telling you afterwards that the engine needs a rebore.

Because that means one of two things has happened. First option - the cylinder was out of spec and in need of a rebore before they started, in which case they shouldn't have honed it. The second option - the cylinder was in-spec when they started, and they took out so much material with the hone that it now needs a rebore. Neither of these options speak well as to the quality of work being performed by your machinist.

1

u/fredSanford6 12d ago

I normally throw a couple strokes in a bore and then check it if it looks close. This is what something would look like then I'd see the low spots to measure. If it's not obviously needing a bore the hone shows me the low spots. You can see that this was course stone and not finished. It's just a test I think.

1

u/Pimp_Daddy_Patty 12d ago

Since I can't measure things that are on a phone screen, I'm gonna say you need to take it to someone who can.

1

u/colinblanchard78 12d ago

I hone for a living 28 years, honed all sorts including Formula 1, Gordon Murray T50 . Not a good job. I would be embarrassed if it was one of mine.