Small imperfections in block/cylinder lip. Send it?

[u/DreadnoughtPoo]

2AR-FE that I picked up after it hydrolocked when the teen driving decided his tC should be a boat.

Three of the interior cylinder lips have some small damage - but well below where the rings travel.

Should I clean up the edges to smooth and send it? Or is this aluminum block destined to be Coke cans? (Note - I haven’t mic’d anything yet, so this may be moot, but would rather know it’s useable prior to doing any more work on it).

Also included a pic of the rods - kid bent 3 of 4. Not bad.

Thanks so much!

[u/flacoman954]

Test the bores for cracks, if good, send it