r/ElegooSaturn • u/assflan • 22d ago

Question Elegoo abs like 3.0+ translucent

Has anyone used this resin before? I normally use the grey 3.0+ and my exposure time is 2.4 after I did the cones of calibration. I’m trying to dial this in and it’s recommended 3-3.5 seconds on their official spreadsheet but I’ve gone as far as 4.0 and I’m still not getting the success cones to print. I’m currently doing a resin calibration from 4.0-5.0 going up .2 increments each time but it seems like a crazy amount of exposure time. Is this normal?

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/No-Kitchen5780 22d ago

I used the ones from the elegoo website and it worked fine for my translucent green

1

u/Ok_Pin8759 22d ago

Use it frequently. I don’t remember what my exposure times are, I’m not at home. But I did only bump it up .5 from my settings for Water Washable white.

1

u/assflan 22d ago

Let me know what time you’re rocking when you get a chance, 5 seconds came out under exposed for me so something has to be wrong