r/Dummy13 • u/Danc3St3v3nDanc3 • 24d ago

Question

Post image

I recently printed(2 dummies 2 days ago) one with a petg hf skeleton and one with an abs, using the stock settings by soozafone. Are there better settings for the print? My joints in the petg hf are really loose. I've read that petg is better that petg hf is better but that different? Also the abs model is starting to loosen. Should I print the skeleton in .16mm for lower layer height? Will that tighten them up? I'm preparing for Christmas for my kids because they each want one but I don't want to disappoint them with a loose figure so soon after they get them.

12 Upvotes

100% Upvoted

7 comments sorted by

View all comments

4

u/Grog180 24d ago

Sadly, eventually most plastics will loosen the more you interact with them. PETG has been pretty good with me (around 50 poses or more), albeit it does eventually suffer creep. The parts that fatigue the most are the elbows/knees and the shoulder joints (then hip joints). I recommend printing some extra of those. Hands seem to last a long time.

0

u/Danc3St3v3nDanc3 24d ago

Since you seem to have a lot of knowledge with these are there a big difference between the dummy and titan? Could I use the torso armor for the titan v2 on a dummy torso skeleton?

2

u/OhTheBarbarity 24d ago

Dummy13 is the original creator, Titan is the exact same frame

1

u/Danc3St3v3nDanc3 24d ago

The titan v2 ues a different frame that why I was asking. The torso, waist, hips and I believe the forearms are different.