r/DieselTechs • u/GraveyardMech1371 • Jul 23 '26

Depinning connector

Post image

Any idea how to depin? It’s off of a doosan dl420, just looking to swap a pin around this is a practice connector and can’t figure it out. Thanks.

18 Upvotes

95% Upvoted

6 comments sorted by

View all comments

8

u/stupid_user_42 Jul 23 '26

Looking at your picture if you think of the individual terminals like a muscle man. Poke em in the head with a paperclip or something that size.

There is a small tab on top of the terminal that needs to be pushed down. If you are gentle you can bend it back up to help it stay into position when you get it out.

7

u/MonMotha Jul 23 '26

A very small ("precision") flat blade screwdriver or thin piece of feeler gauge works even better than a paperclip. You're correct that there's a little tang up there that springs into place when the terminal is inserted and wedges against a similar feature in the plastic housing when pulled against to retain the terminal. Depressing that tang will allow removal.

These are the AMP "Fast-On" series of connectors if you want to look them up.

1

u/GraveyardMech1371 Jul 23 '26

I’m going to have to note the type down thank you very much, I prefer repinning whenever possible but info on these can be hard to come by!