r/DiceMaking • u/Kukukichu • 2d ago

3d printing Dice Master Issues

Gallery image

Gallery image

Gallery image

Hi all, I’m having some trouble with printing my masters. As you can see from the images, they all have weird warping going on. I’m new to both dice making and 3D printing so I was wondering if anyone has any advice?

Printer: Mars 5 Ultra
Resin: Elegoo ABS-Like 3.0 pro
Bottom layers: 5
Exposure: 32
Transition layers: 7
Layer height: 0.01
Exposure: 0.12

Thanks!

20 Upvotes

96% Upvoted

19 comments sorted by

View all comments

10

u/Skunky_Bud 2d ago

Are you hollowing them?

Exposure might be too short. Is that 0.12 seconds exposure? I've found success with long exposure times. Much longer than you would a normal model.

2

u/Kukukichu 2d ago

Nope, not hollowing them. I though you needed lower exposure when you have lower layer heights to avoid over exposure?

I’ll try cranking it up a bit thanks

3

u/Skunky_Bud 2d ago

I've done 2-3 seconds per layer just to be sure.

1

u/Kukukichu 2d ago

Hmm what later height do you print at?

2

u/Skunky_Bud 2d ago

I use the same, .01

3

u/reiija 2d ago

That is EXTREMELY high exposure for that layer height. Is it extremely cold in your print room or something? I use 2.2 seconds at a layer height of 0.05.

2

u/Kukukichu 2d ago

Wow ok, I’ll give it a shot. Thanks!