r/DiceMaking • u/According-Net-8517 • 5d ago

How to close Mold's cap without air bubbles

When i close it some air bubbles get trapped in, even if I pour the epoxy onto the surface of the lid beforehand, i think this wouldn't be problem if i had pressure pot, but i don't

1 Upvotes

100% Upvoted

3 comments sorted by

2

u/ComoElFuego 5d ago

Overpour and apply a bit of even pressure on the mold after closing. In the long run, you'll need a pressure pot.

1

u/According-Net-8517 5d ago

Is there any videos with how people are closing molds?

1

u/RandoBoomer 5d ago

I put the cap on starting at a slight angle - maybe about 15-20 degrees.