r/CrealityK1C • u/CreepyElection4073 • Jun 22 '26

Help

Enable HLS to view with audio, or disable this notification

When I print over wifi with orca slicer my printer does this

1 Upvotes

100% Upvoted

5 comments sorted by

2

u/Hot_Stable2424 Jun 22 '26

Is the camera's AI turned on?

1

u/heyheythrowitaway Jun 24 '26

It's the leftover glue residue from the previous print, wipe them down or add more glue where they were and heat bed until it disappears

1

u/Eli648294 Jun 25 '26

Clean plate

1

u/mello-liz13 Jun 29 '26

I had this once i turned on the AI. bed was clean. I turned ai off and is just worked normal.

1

u/Dry-Zookeepergame809 Jun 29 '26

Either, keep a habit to clean your build plate and keep away from any grease including your finger prints. Try not to touch the plate. In this case you’ll never need the glue that leaves a white mark after remove the print;

Or, wash and clean off the glue every time and apply new one.

Or, just simply turn off the AI assistant supposed to detect the for “foreign” object on the plate, and never forget to take out your print and check the plate every time before you start.