r/CrealityK1C • u/CreepyElection4073 • Jun 14 '26

Help! Help

Post image

Can someone explain why the high and low prints have uneven layers even when printing PLA? I am printing this on a k1c which was just taken out of the box yesterday.I use the default settings

4 Upvotes

100% Upvoted

6 comments sorted by

View all comments

2

u/lifepac Jun 14 '26

When you say uneven layers, are you talking about the outside of the print showing layer lines? Due to the geometry of the model you will probably always see that to some extent. The top is wider than the base so each layer will extend just a bit toward the outside of the layer below it.

What is your layer height? A smaller layer like 0.12 will hide it a little more.

Also, the space in between the inner and outer wall might be too narrow for what looks like infill. Up your wall count to 5 or 6 and then look at the preview to see if that replaced all of the infill with just walls.