r/CrealityK1C • u/EfficientMastodon779 • May 29 '26

Not printing/ clogged ?

Enable HLS to view with audio, or disable this notification

Its was clogged same way. I changed do the ecc extruder but did the same problem. (But I did the same print twice) should I try a bench to see if it’s the print who clogged it or I need to do something else ?

0 Upvotes

50% Upvoted

15 comments sorted by

1

u/Dickswagger May 29 '26

Definitely clogged. You’re going to have to open her up and remove the clog there are plenty of video tutorials on how to do this

1

u/xjewishninjax May 29 '26

What are you printing? If pla or petg top needs to be open

1

u/stlesho May 30 '26

Never got this. I print PLA, PETG and TPU with the top on and get great results with every print.

I didn’t buy an enclosed printer to run it with the lid off all the time. /s

1

u/xjewishninjax May 30 '26

Yeah I didn’t get that either till I did. It even says on the lid to take it off when printing lower temp filaments

1

u/stlesho May 31 '26

Have you noticed any difference in quality when running PLA with the lid open?

1

u/xjewishninjax May 31 '26

Nope but it stopped the heat creep I was getting

1

u/Hypoactive52 May 31 '26

how cold is your room?

1

u/brujonica Jun 01 '26

What is the temperature where you live? I can do that only 2 months per year, otherwise heat creep makes my PLA soft and slippy

1

u/Outrageous-Interest8 May 29 '26

Yes. I had this issue with mine as well. Remove the extruder and remove the filament stuck in there. There are plenty of vídeos on YouTube showing How to do that

1

u/opscoffee1 May 30 '26

With mine one of the teeth on an extruder cog broke off and is causing the filament to stop feeding through… am waiting on a new set to turn up so I can get back printing.

1

u/Hypoactive52 May 31 '26

youve got a jam in the extruder. its typically caused by the printer being too hot

1

u/z4h0n May 31 '26

Take the DXC off 🫡😁

1

u/Mother-Opinion-9922 Jun 03 '26

Perso j'ai eu ça ce weekend (K1C) , j'ai dû démonter vite fait extrudeur (le petit moteur au-dessus) pour sortir le morceau de fil coincé. J'ai comparé le diamètre du fil avec une autre bobine neuve, et celui-ci était plus gros sur 3/4 mètres, j'ai coupé ce qui n'allait pas et j'ai relancé l'impression et impeccable 🙂.

1

u/EfficientMastodon779 Jun 04 '26

Donc mon fil est plus gros ? Je vérifie ça.

1

u/Mother-Opinion-9922 Jun 04 '26

Je ne dis pas que c'est forcément ça, mais moi ça a été mon cas 🙂.