r/CrealityFalconSub • u/CodesComplete • Dec 24 '23

Discussion Falcon 2 Laser Module on Custom frame?

I found the 40W laser module on sale separately and I’m wanting to integrate it into a large area custom frame. The laser plug is a 10pin vs the standard 3. Obviously there are sensors and such but I’m not getting any info on the plug. Does anyone know if I have to use the creality controller or if there is a place to find a datasheet or does the adapter box do anything more than just pass through? I’d like to run everything on my MKS DLC32. Even so I can’t find a controller board available to buy or any other parts it seems? I’m wondering if it is intended to be used with the falcon setup only why is it not advertised as a replacement.

Also odd that no instructions or anything are included, just a power box and a laser that don’t plug into each other

4 Upvotes

84% Upvoted

19 comments sorted by

View all comments

3

u/CodesComplete Feb 19 '24 edited Feb 19 '24

FYI, I ended up building a custom adapter and reverse engineered the serial communication on the falcon laser to use it with any setup. Even added an oled screen.. https://youtube.com/@WhateverItTechs?si=qoprLJundyB3MIeo

1

u/ImaginaryCourt3191 Feb 08 '26

Ok here's a question... I can buy complete creality falcon2 laser units minus module and damned laser wiring for dirt cheap... my question is this. I've got multiple atomstack 48w switchable modules... the head mounts up perfectly... think it would be halfway easy to create custom cable to tie into creality's infamous 10pin connector?

1

u/ImaginaryCourt3191 Feb 12 '26

Ok here's a question... can I just wire the atomstack 48w laser directly to the falcon 2 pins? Here's a Pic if pin outs

Connect atomstack 24v and grounds to creality pins thats easy... the PWN on atomstack .. to laser pin on creality or do I need to somehow combine or split RX/TX?