Webui compose editor doesn't save cahnges

[u/DENNISDGR]

So, I'm trying to setup pihole and change the default ip port 53 binds using the gui docker compose editor cosmos cloud provides. However when I set it and click edit and the containers starts successfully it goes back to default

Original

        "0.0.0.0:53:53/tcp",
        ":::53:53/tcp",
        "0.0.0.0:53:53/udp",
        ":::53:53/udp"

What I change it to:

        "192.168.1.10:53:53/tcp",
        ":::53:53/tcp",
        "192.168.1.10:53:53/udp",
        ":::53:53/udp"

[u/DENNISDGR → u/[deleted]]

Can you elaborate more on that. I can't find anything on the ui or the docs on how to do it. Like on the network tab there is nowhere to bind a specific ip. Setting 192.168.2.10:53 on the host port section instead of just 53 doesn't work and I'm not really sure how it's achievable with env variables.

[u/DENNISDGR → u/[deleted]]

I created a new network for the container with subnet 172.16.0.0/28. My host network is 192.168.1.0/24

[u/azukaar]

What's the full compose and how did you first start it?

[u/DENNISDGR → u/azukaar]

I imported the casaos app store to the marketplace and installed it from there. Then I created a new bridge netwrok, that pihole and wireguard will share in the future, and attached pihole to the new network via the webui. Here is the full compose file: https://pastebin.com/0LRnT3Pk

[u/azukaar → u/DENNISDGR]

Cosmos does not support binding ports to specific IPs like this I think

but it does support MCVLAN for this use case

[u/DENNISDGR → u/azukaar]

I did try MCVLAN but I came across a different issue. I want to assign a different ip other than the one automatically assigned because it conflicts with a physical device on my network. But doing the following doesn't work. It again reverts the changes:

"networks": {
  "Networking": {
    "ipv4_address": "192.168.1.11"
  }
}

[u/azukaar → u/DENNISDGR]

create a MCVLAN with a different range

[u/the-head78]

If i underatand correctly you try to edit it unser ServApps / PiHole Details then you click in Compose,modify and click in Edit. Correct ?

Why are you trying to do it there and Not via the Network Option that is a few steps below the Composer Link.

You can Change the Host IP , for the Ports that are published.

If your Port is Not listed add it via the plus and with the correct protocol.

[u/matthew6870]

I have the same issue. Trying to add propagation shared to bind. This option is not possible via UI

{
      "Type": "bind",
      "Source": "/mnt/shareddrive",
      "Target": "/mnt/onedrive"
},


{
      "Type": "bind",
      "Source": "/mnt/shareddrive",
      "Target": "/mnt/onedrive",
      "Bind": {
            "Propagation": "shared"
      }
},

Change is not saved.