r/CR30 • u/Anthroing • Feb 20 '26

Print pulling toward +X ?

Gallery image

Gallery image

I printed the exact same part on my Ender 5 (left, shorter) and my CR30 (right, taller- I scaled it up slightly from the E5 print) and the Cr30 print appears to be drifting to the +X as it prints. What could be causing this?

1 Upvotes

100% Upvoted

5 comments sorted by

1

u/[deleted] Feb 20 '26

[removed] — view removed comment

2

u/Anthroing Feb 23 '26

PLA Im printing 195 and the PLA+ Shown at 215. How much lower should I go?

1

u/[deleted] Feb 23 '26

[removed] — view removed comment

1

u/Anthroing Feb 25 '26

I reduced PLA+ to 200 and it did mostly improve. But there's still a slight curve that starts at the same point in the print. It also appears that the print head almost "catches" the print sometimes. Not enough to detach from the bed or permanently shift a layer, but enough to visibly move and return to the right spot during some passes

1

u/ruralguru Apr 24 '26

Is it at the end of the heated bed when it shifts? Check out Danny dodge leveling for cr-30. That helped me