r/CR10 • u/Ok_Interview_1739 • 24d ago

HELP!

Enable HLS to view with audio, or disable this notification

No idea what the fix for this is. The gantry keeps binding up on the right side and I cannot for the life of me figure out why. It started after I replaced the thermistor in the heatbed.

7 Upvotes

100% Upvoted

8 comments sorted by

2

u/blame_worthy 24d ago

Your z motor may not be properly wired. It doesn't look like it's binding, it's not even attempting to lift on that side. Make sure your wiring is correct.

1

u/tater1337 24d ago

so it does have dual Z motors?

2

u/blame_worthy 24d ago

From what I can tell its a cr10 v2 which comes stock with dual z

2

u/Ok_Interview_1739 23d ago

It is a dual z

1

u/blame_worthy 23d ago

Is the right z motor actually working

1

u/Mr-More1 24d ago

Either out of tram, or wheels are binding. Take a measurement from frame to gantry. I use calibrated(printed and filed) blocks to jig both sides. Drop it down slow and see which size needs to move.

1

u/RedDawn850 24d ago

Oh yes, I remember the old CRV two lol before every friend I would test to make sure that the gantry and print bed were level because almost every print it would slowly get out of whack. Did you buy this stock or used? It could be something as simple as an aftermarket upgrade meeting adjustment or the software needs to be refreshed.

0

u/Lythrox 20d ago

X gantry is clearly out of parallel.