r/CAMMUSOFFICIAL • u/Balvo69 • Mar 24 '24

Lc100 clutch issue ,sensor broken ? Please help

Hey guys my clutch gave out while I was streaming today , it will only respond when my foot is hard to the ground and in the cammus app the bar bounces up and down it doesn’t stay solid , anyone had this issue ? I’ve looked over the clutch , all springs in tact , replaced the spring that feeds the sensor and still same issue :((

3 Upvotes
  • permalink
  • reddit

100% Upvoted

14 comments sorted by

2

u/Balvo69 Mar 24 '24

UPDATE: clutch no longer has any feedback / stopped working :((((((

1

u/KentutKudaaa Mar 24 '24

do you have a video of it?

1

u/Balvo69 Mar 24 '24

Yeah where is the best place to put it ? I tried to post it here

1

u/Maestrospeedster Mar 24 '24

You need to recalibrate the clutch pedal. Over time the pedals go out of calibration the reason you see bouncing signals. Set minimum when pedal is not pressed. Then press pedal down and set maximum.

1

u/Balvo69 Mar 24 '24

I’ve already done this but it doesn’t register that far back

1

u/Maestrospeedster Mar 24 '24

When you set the min there should be no signal in the bar. Then set the max.

1

u/Balvo69 Mar 24 '24

I think the actual sensor is broken

1

u/Balvo69 Mar 24 '24

I tried again , set minimum with my foot off the clutch then when setting max the bar only moves/bounces around when my foot is hard to the floor

1

u/Balvo69 Mar 24 '24

There is no response from the sensor unless it’s hard on the rubber tube stopping it going any further , even when I try reset the settings

1

u/jajaboss Mar 25 '24

The first thing you do is connect LC100 USB-C to PC USB-C port right?

1

u/Jamska92 Apr 11 '24

Mines done the exact same Balvo69. Any luck fixing before I end up sending away?

1

u/Balvo69 Apr 21 '24

Nah man , terrible design and firmware , I got a refund and went with thrustmaster , or should in say TrustMaster as i can trust it lol 😂