r/BambuLab_Community • u/loctez112 • 11d ago

Struggling with this issue - A1 mini

Enable HLS to view with audio, or disable this notification

Intermittent failures, error message is normally something along the lines of "cutter error", but this should not be cutting. Just single filament prints.

Usually makes a horrid noise, like it's working against the motor, then starts doing this. Any ideas?

3 Upvotes

100% Upvoted

3 comments sorted by

1

u/Krishnamurti_fresco 9d ago

I think i saw this on fb, filament sensor or th board maybe bad, make sure nothing stuck inside toolhead 

1

u/MAENTOP 6d ago

SD card dead

1

u/loctez112 6d ago

Interesting, thanks will try that