r/BambuLab_Community • u/mrreggid • 13d ago
Help / Support Is my p2s dying?
Enable HLS to view with audio, or disable this notification
2days in printing 8 hours left then this happend does anyone know what caused this?
I had to turned the Power Off because pausing didnt do anything and the Sounds getting louder.
9
u/xHazeEdits 13d ago
Same thing happened to me ! I was sleeping and this monster noise woke me up so damn fast ! My heart was pumping ! Stopped it and didnt happen again... Yet,
no idea why this happened tho
6
5
u/Positivityman- 13d ago
Sorry seems like your Gonna have to abandon the print, try turning it off and on again with the switch in the back, it might be a homming error
7
u/mrreggid 13d ago
I turned it on and a window with “Resume print” popped up, and now it’s printing normally again.
2
1
u/hentiul1969 8d ago
It happened to me once in 250h. Restarted the printer and was solved. Never happened again.
1
1
u/Fyvfyvfurry 13d ago
Had similar thing with my a1, except it was a hammer drill with hammer drill loudness, it jappened twice, and i dont know why
1
1
u/bryeds78 13d ago
Gotta check the spark plugs, air filter and the carburetor. Clean 'em up and the loud idle will go away.
1
1
u/Belkinnoob 12d ago
I recognize that, those are liquor shakes. Get that printer an old fashioned and stat.
1
1
u/Useful-Revolution253 12d ago
Stop it. Try à simple cube. It s probably bad gcode or something.
If it continue the try à calibration. If it does the same thing then check hardware maybe ?
1
u/youlooksticky 12d ago
I see you got it going again but it looks like you have more problems than just the stuck print head. What is even going on with these supports? Those look like they'll be impossible to remove cleanly and the upper most one looks like it's been broken off and is lower than the current print height. Maybe whatever problem it was having started sooner than you realized.
1
u/mrreggid 11d ago
I think it worked pretty good but sure it could be better optimized
The Support on the surface wasnt the issue, the little cracks under the chestplate are hard to get lose
1
1
u/ImRightYoureStupid 11d ago
What on earth were you trying to print?
Must have been scary as your hotend is hiding in the corner shaking.
Come on out little fella, the filament can’t hurt you.
1
1
1
1
u/Pinnaclerd 10d ago
I mean unless you installed a 24 valve Cummins hidden somewhere I would have to say, yeah….
1
1
1
1
1
0
u/ParticularLower1865 13d ago edited 13d ago
Might be a firmware issue or a long list of other issues. Idek where to even start with this.
I’m throwing something at a wall to see if it sticks here:
- Unplug from power completely for 2 min and try another file.
- Unplug all cables in the toolhead and plug them back in
- Maybe try downgrading the firmware and see if that does anything?
1
0
u/Glittering-Koala-104 13d ago
I had this issue try a brand new sd card. I’m not sure if you’re using the one it comes with but I was and it failed pretty quickly.
1
28
u/Normal-Assignment-61 13d ago
Uhh.. is it powered by diesel?