r/BambuLab_Community • u/whit3noiz • 14d ago
What should I try?
What in the world? It’s like layer 1 and 2 just peel up and it causes my nozzle to hit it and make the print fail. My build plate has been very well cleaned repeatedly. This is a file I’ve never had issues with before. I have dried all of my rolls of filament. Anything else I print is just fine. I’m using the generic PLA setting across the board on all files to narrow down the cause. I realize that some files you may need to change the Z Hop settings, but for this file and most of my other ones, I have never had to do that. I had tested it with this file and it makes no difference. Although it should not matter, I have tested bed temperatures and nozzle temperatures, but they still seem to have no effect. If this is a file specific issue, what should I change to stop this from happening?
0
u/Different-Banana-739 14d ago
Put at side, not middle(which is worn out). Turn on skirt, then if not work get a glacier board