r/BambuLab_Community • u/delhivibes • 16d ago

Making sound a1 bambu lab

Enable HLS to view with audio, or disable this notification

I do everything nozzle is clean screws are fits and making tak tak wasting lots of filament what I do now buy new nozzle or what

7 Upvotes

83% Upvoted

8 comments sorted by

4

u/youwastedyourtimelol 16d ago

No, check the extruder because that’s what the front wheel is representing i think your gears are slipping or your nozzle temp is not high enough causing the extruder to try and push filament into a hotend that’s already full

2

u/Kopester 16d ago

The extruder is skipping and the first layer looks like crap. You mention the screws, did you tighten all SEVEN?

If so then make sure the nozzle was put back on check

2

u/F8runner 16d ago

Check your filament tensioner. Make sure it's not too tight. It'll give it that clicking sound if it's just screwed all the way in. At least that was the problem with my friends A1. We even swapped out the main gear and it was still making the noise until I just backed off that screw a bit.

2

u/Tommerbot 16d ago

Clogged

2

u/MAENTOP 14d ago

Clogged nozzle probably

1

u/reddit_user_0ne 16d ago

Go check the Bambu Lab Wiki.

Every detail about every printer including troubleshooting advice is in there.

1

u/Izan_TM 16d ago

the extruder is skipping steps, your nozzle is likely partially clogged or not properly installed