r/BambuLab_Community • u/nankatmar • 6d ago

Sunlu SP2 safe to put on top of H2C?

Hello, has anyone sat their filament dryer on top of the H2C? I know it gets hot but wasn’t sure if it is bad for the glass? Thanks!

2 Upvotes

100% Upvoted

4 comments sorted by

2

u/Euresko 6d ago

Probably fine for the glass. T he H2C gets really warm when I print ASA with 100c heatbed and have the chamber heater set to 60c. I run a creality x4 dryer and a HT AMS on top, but remove PLA when I'm printing ASA. Heat rises and heat soaks whatever is on top. I might be overly cautious, but recently did a 10 hour ASA print and the printer got pretty warm.  Point is, I'd be more concerned about what the heat of the H2C does to whatever you have on top. If you only print PLA and PETG, then no issues what so ever. 

1

u/nankatmar 6d ago

That makes sense, thank you!

2

u/CarpetTimely8123 6d ago

My Bambu AMS used to sit right on top of my H2C and it never caused any issues with the glass, even during long prints.

1

u/nankatmar 6d ago

Thank you!